Hi Olivier,
Am Mittwoch, den 21.02.2007, 16:04 +0100 schrieb Olivier:
> Hi Karsten,
>
> Do you mean no one can read Layer3 info from Layer2
data or do you
> just mean it would be easier to read Layer3 ?
It would be easier to read layer 3.
>
> As you guessed, at this point, I'm rather after Layer3
data but I'm
> trying to debug something which happen from time to
time.
> I had a chance to catch it while PRI INTENSE DEBUG was
turned on.
>
> I'm hoping I don't have to do it again with PRI DEBUG
enabled.
>
> To be more specific, the issue is that the Network
replies it is
> congested and I don't think it should be the case.
Your Debug-Output shows two layer 2 frames. The first one
(lines 2140 to
2155) is an I-Frame. It holds a Q931 Paket with the message
type
"RELEASE COMPLETE" and the cause info element
"congestion".
The second frame (lines 2158 to 2163) is a RR-Frame as an
acknownledgment for the I-Frame.
Your debug output does not show the events before the
"RELEASE
COMPLETE". IMHO with this little piece of debug it is
impossible to
check why there is a congestion. Btw. there are more reasons
for a
congestion than "all local B-Chans busy". The
Release comes from the
ISDN cloud. Maybe Your provider can help You?
Regards,
Karsten
_______________________________________________
Bristuff-users mailing list
Bristuff-users lists.three-dimensional.net
http://lists.three-dimensional.net/mailman/lis
tinfo/bristuff-users
|