Hello again,
I need help with setting my ISDN line. I was thinking about
mailing
freebsd-isdn but I got help here so I'm trying again 
I have working i4b and also chan_capi installed. And.. I
have no idea
what to do next. My ISDN line is working - I have plugged it
to ISDN
phone and it worked fine. When I plug it into my card I have
PH-state F3 - deactivated
I've experimentally put my card in pcm_master, then
pcm_slave.
PH-state was then in F8: Lost framing, sometimes jumping for
a second
to Synchronized or Active. Now it is again in F3 and stable.
[rootasterisk ~]# isdnconfig
controller 0 = {
Layer 1:
description : HFC-2BDS0 128K PCI ISDN adapter
type : passive ISDN (Basic Rate, 2xB)
channels : 0x3
serial : 0xabcd
power_save : on
dialtone : enabled
attached : yes
PH-state : F3: Deactivated
Layer 2:
driver_type : DRVR_D_CHANNEL
}
When I run capitest -i 1 -o 1 I get this in dmesg:
i4b-L3 cd_set_state: cdid=384, persistent L1 deactivation -
check ISDN
cable
I believe that before I will proceed with asterisk
configuration
I have to get isdn line working. But I have no idea what
should I do,
what driver_type set up etc. Again, any help would be
appreciated. Tell
me to get out to freebsd-isdn if this list isn't
appropriate. TIA!
--
.: Jakub Głazik,
.: too geek to live, too leet to die
.: email & jabber: zytek<at>nuxi.pl
_______________________________________________
--Bandwidth and Colocation Provided by http://www.api-digital.c
om--
Asterisk-BSD mailing list
To UNSUBSCRIBE or update options visit:
http://lists.digium.com/mailman/listinfo/asterisk-bsd
|
