jhalfs-1.0, so far OK but what now ...

Hi,

 

I’m just a newbie so please understand

 

I’ve been trying to figure it out how to automate my lfs build but no success

Everything seems to be OK, all configs except for kernel config and fstab

but I’ll deal with those later

 

This is how it looks:

 

lfslivecd:root | mån  7 aug 2006 19.29.09 | ~/jhalfs-1.0

# ./lfs -D /mnt/lfs -M -G -B 6.2

KERNEL: <2.6.16.27> ..OK

BASH:   <3.1.17(1)-release> ..OK

GCC:    <4.0.3&gt; ..OK

TAR:    <1.15.1> ..OK

------------------------------------------------------------------------------

BOOK: <lfs-6.2>

BUILDDIR: </mnt/lfs>

SRC_ARCHIVE: </mnt/lfs/sources&gt;

GETPKG: <1>

RUNMAKE: <1>

TEST: <1>

OPTIMIZE: <0>

REPORT: <1>

COMPARE: <0>

STRIP: <1>

FSTAB: <>

CONFIG: <>

GETKERNEL: <0>

VIMLANG: <1>

PAGE: <A4>

TIMEZONE: <Europe/Stockholm&gt;

LANG: <sv_SE&gt;

*** lfs config parameters look good ***

------------------------------------------------------------------------------

Are you happy with these settings? yes/no (no): yes

------------------------------------------------------------------------------

Downloading the lfs document, 6.2 version... done

Creating LFS specific URLs file ...OK

cp: "/mnt/lfs/sources/autoconf-2.59.tar.bz2" och "./autoconf-2.59.tar.bz2" är samma (the last one here says “is the same”; when the file already exists)

        Goodbye and thank you for choosing <jhalfs>

 

 

.. now here is the problem, everything stops here and what now, shouldn217;t it start building further???

I have been looking around the internet a bit and I haven̵7;t found anything reasonable about jhalfs-1.0

Every document about jhalfs says that I shout type ./lfs R30;. and it should start downloading packages and start building

But no luck for me or perhaps it’s my English that’;s a bit rusty J

 

Any help would be appreciated

 

THX