Upgrade to R61 or R62?

I had a similar issue just upgrading from R60 HFA3 to HFA4
on the
SmartCenter itself. In my case I just ran cprid start on my
firewalls
and everything was good again. 


Jeremy Lieb CCSE-NG CCSE+NG
Firewall Administrator
Open Text Corporation
100 Tri-State Int'l Pkwy
Third Floor
Lincolnshire, IL 60069
18472679330  ext 4395
 

-----Original Message-----
From: Mailing list for discussion of Firewall-1
[mailto:FW-1-MAILINGLISTAMADEUS.US.CHECKPOINT.COM]
On Behalf Of Fred
Katsumi
Sent: Wednesday, November 22, 2006 2:17 PM
To: FW-1-MAILINGLISTAMADEUS.US.CHECKPOINT.COM
Subject: Re: [FW-1] Upgrade to R61 or R62?

Hi all,

Just an update.  I went ahead and upgraded the smartcenter
from R60 to
62.  That went pretty smoothly.  But after the upgrade I
kept getting a
communication error between one of the firewalls (R60) and
the new
SmartUpdate when I tried to Get Gateway Data or Pre-Install
Verifier.
The error was:

Unable to connect. Make sure that: the network connection is
up, trust
is established, and cprid connections are allowed

SIC was fine and I could still push the policy.  Checked to
make sure
CPRIP is running and even reset SIC.  I ended up
uninstalling R60,
cleaning it and rebuilding the gateway as R62, which is not
a big deal.
Now everything looks to be in order.

Fred

----- Original Message -----
From: Mailing list for discussion of Firewall-1

=================================================
To set vacation, Out-Of-Office, or away messages, send an
email to
LISTSERVamadeus.us.checkpoint.com
in the BODY of the email add:
set fw-1-mailinglist nomail
=================================================
To unsubscribe from this mailing list,
please see the instructions at
http:
//www.checkpoint.com/services/mailing.html
=================================================
If you have any questions on how to change your subscription
options,
email fw-1-ownerts.checkpoint.com
=================================================

=================================================
To set vacation, Out-Of-Office, or away messages,
send an email to LISTSERVamadeus.us.checkpoint.com
in the BODY of the email add:
set fw-1-mailinglist nomail
=================================================
To unsubscribe from this mailing list,
please see the instructions at
http:
//www.checkpoint.com/services/mailing.html
=================================================
If you have any questions on how to change your
subscription options, email
fw-1-ownerts.checkpoint.com
=================================================