According with the Hardware Compatibility List in the Check
Point website:
http://www.checkpoint.com/services/techsupport/hcl/al
l.html
Your 1950 with PERC controller is supported starting from
R60, if you are
trying to install R60 o R61, you will need a particular ISO
and will need
help from the support guys at CP, if you are going for R62
or R65, then you
you should have no problem. Otherwise you might have a
faulty disk of
hardware.
Regards
On 9/4/07, Jørn Dahl-Stamnes <fw.admin dahl-stamnes.net> wrote:
>
> On Tuesday 04 September 2007 15:57, pkc_mls wrote:
> > Gil Hananya a écrit :
> > > Hi,
> > >
> > >
> > >
> > > I'm trying to install splat on new Dell
PowerEdge 1950 with PERC 5
> raid
> > > controller, but can't get it install.
> > >
> > > I think I need driver for the PERC.
> > >
> > > Please advise/help
> >
> > hello,
> > if the server is on the HCL from checkpoint
website, they should
> > indicate which release is required.
> > ie which version + which take number.
> > if you don't have this specific version, but you
have a proper contract
> > with checkpoint, you can ask
> > for an iso and they will put it on their ftp
server just for you. (only
> > the iso for r65 is available from the main
download site).
>
> I had the same problem. It turned out that I had
downloaded the wrong ISO
> file. When I got the right ISO file, it worked OK.
>
> --
> Jørn Dahl-Stamnes
>
> =================================================
> To set vacation, Out-Of-Office, or away messages,
> send an email to LISTSERVamadeus.us.checkpoint.com
> in the BODY of the email add:
> set fw-1-mailinglist nomail
> =================================================
> To unsubscribe from this mailing list,
> please see the instructions at
> http:
//www.checkpoint.com/services/mailing.html
> =================================================
> If you have any questions on how to change your
> subscription options, email
> fw-1-ownerts.checkpoint.com
> =================================================
>
--
Sergio Alvarez
(506)8301342
=================================================
To set vacation, Out-Of-Office, or away messages,
send an email to LISTSERVamadeus.us.checkpoint.com
in the BODY of the email add:
set fw-1-mailinglist nomail
=================================================
To unsubscribe from this mailing list,
please see the instructions at
http:
//www.checkpoint.com/services/mailing.html
=================================================
If you have any questions on how to change your
subscription options, email
fw-1-ownerts.checkpoint.com
=================================================
|
