Q about '(g)make test'

Hi,

after the (g)make I normaly run the '(g)make test'.

I get the follwoing error when I run it on my sol11 box:

---
sol-expr al ~/cherokee/cherokee-0.5.5 $ gmake  test
gmake -C qa test
gmake[1]: Entering directory
`/export/home/al/cherokee/cherokee-0.5.5/qa'

./run-tests.py
PID: 10056 - ../cherokee/cherokee

module_loader.c:226: ERROR:
dlopen(/export/home/al/server/cherokee/lib/cherokee/libplugi
n_read_config.so):
ld.so.1: cherokee: fatal:
/export/home/al/server/cherokee/lib/cherokee/libplugin_read_
config.so:
open failed: No such file or directory

module_loader.c:378: ERROR: Can't open
"read_config" module

Couldn't read the config file
Basic:                                     Couldn't connect
to the server
gmake[1]: *** [test] Error 1
gmake[1]: Leaving directory
`/export/home/al/cherokee/cherokee-0.5.5/qa'
gmake: *** [test] Error 2
---

which is clear due the fact that I haven't installed
cherokee yet.

My ./configure --prefix=/export/home/al/server/cherokee

---uname -a
SunOS sol-expr 5.11 snv_40 i86pc i386 i86pc
---

Thoughts?!

Regards

Aleks
_______________________________________________
Cherokee mailing list
Cherokee0x50.org
http://www.0x50.org/cgi-bin/mailman/listinfo/cherokee