Got that too...
One thing I was wondering-- If I monitor port g3/4 on the
4500 both
directions-
Does the packet go thru the incoming service policy before
it is
mirrored over to the destination monitor port?
Later,
jim
-----Original Message-----
From: Ted Nugent [mailto:tednugent69 yahoo.com]
Sent: Saturday, July 29, 2006 11:44 PM
To: Jim McBurnett; cisco-voippuck.nether.net
Subject: Re: [cisco-voip] 3560 QOS bug?
Also check your trunk to the 4500 and make sure your
trusting DSCP...
sorry to state the obvious.
--- Jim McBurnett <jimtgasolutions.com> wrote:
>
>
>
> Has anyone seen a bug where a 3560 with a QOS config
will remove the
> EF DSCP tagging on a packet as it traverses the switch?
> I have a packet capture where a packet came in marked
on a Fast E port
> and when it comes into the upstream 4500 it is not
marked EF
> anymore...
>
> Thoughts?
>
> Thanks,
> Jim
>
> _______________________________________________
> cisco-voip mailing list
> cisco-voippuck.nether.net
> h
ttps://puck.nether.net/mailman/listinfo/cisco-voip
>
__________________________________________________
Do You Yahoo!?
Tired of spam? Yahoo! Mail has the best spam protection
around
http://mail.yahoo.com
_______________________________________________
cisco-voip mailing list
cisco-voippuck.nether.net
h
ttps://puck.nether.net/mailman/listinfo/cisco-voip
|