Caller-id name

cname over isnd pri is discussed in primary-ni version 3 
specifification.  it's very similar to name encoding in
qsig.
GR-1367-CORE
SR-4994

CM will not receive/decode this over h323 interface.

/Wes

Andriy A. Yerofyeyev wrote:
> Hello folks,
>
>     Trying to figure out why our AS5350 does not
understand Caller ID
> name , sent by Telco.
>
> Part of Q931 below:
>
>         Progress Ind i = 0x8488 - In-band info or
appropriate now available
> Oct 30 12:13:52.980: ISDN Se2/0:23 Q931: RX <- SETUP
pd = 8  callref =
> 0x0239
>         Bearer Capability i = 0x8090A2
>                 Standard = CCITT
>                 Transer Capability = Speech
>                 Transfer Mode = Circuit
>                 Transfer Rate = 64 kbit/s
>         Channel ID i = 0xA98386
>                 Exclusive, Channel 6
>         Facility i =
0x9F8B0100A10F02010106072A8648CE1500040A0100
>         Progress Ind i = 0x8283 - Origination address
is non-ISDN
>         Calling Party Number i = 0x2183, '5165098757'
>                 Plan:ISDN, Type:National
>         Called Party Number i = 0xA1, '7187323897'
>                 Plan:ISDN, Type:National
> Oct 30 12:13:53.008: ISDN Se2/0:23 Q931: TX ->
CALL_PROC pd = 8  callref
> = 0x8239
>         Channel ID i = 0xA98386
>                 Exclusive, Channel 6
>
> I assume what Telco sent CNAME as Facility IE , but
don't understand why
> cisco cannot decode it.
> Is there any way to tune Facility IE on Cisco ?
> Which standard regulate CNAME over ISDN PRI ?
>
>
>   
_______________________________________________
cisco-voip mailing list
cisco-voippuck.nether.net
h
ttps://puck.nether.net/mailman/listinfo/cisco-voip