Re: DSP prooblems

--- "Wydra, Jason" <jason.wydraberbee.com> wrote:

> If I bounce MGCP my problem seems to clear up but
> then slowly I see PRI channels that don't get used
> again. I'm using perfmon to look at the utilization
> of my channels. Any ideas?

If you want your DSPs to be used, I would first look
at conferencing and transcoding g711 <-> g729.  If
you
have calls going from g711 to g729 or vice versa, you
*should* theoretically see your DSPs being used.




 
____________________________________________________________
________________________
Now that's room service!  Choose from over 150,000 hotels
in 45,000 destinations on Yahoo! Travel to find your fit.
htt
p://farechase.yahoo.com/promo-generic-14795097
_______________________________________________
cisco-voip mailing list
cisco-voippuck.nether.net
h
ttps://puck.nether.net/mailman/listinfo/cisco-voip