The subinterfaces are on the 2811 on port Fa0/0. I have
attempted this setup
of only having vlan 5 with an IP within the same subnet as
the Fa0/1 on the
2811 and still no luck. I went as far as to assign the port
that the Fa0/1
on the 2811 was plugged into on the 3548 to vlan 5. Any
other ideas? Maybe
the IOS is not new enough?
Also, I just did a test and I found that I can only have one
vlan running at
a time. By running I mean to have an IP address and be
reachable by the
directly connected router by the vlan's IP address. The
interface that is
reachable must have the "management" command
executed on it. I am thinking
that this is a limitation of the IOS version, given that it
is 12.0(4) and
the Cisco tests use 12.4. However, I am not aware of
limitations of the IOS,
is there a place I can find this at? Also, if it is a
limitation of the IOS
where can I get a newer version?
On Thu, Aug 7, 2008 at 5:39 PM, jjdorris charter.net
wrote:
> I think you may be going about this the wrong way.
Create the management
> vlan by creating a vlan interface in the correct vlan
and assign the IP
> address that you want to the vlan interface. For
example, if you want vlan
> 5
> to be the management vlan:
>
> interface vlan 5
> ip address 192.168.0.1
> no shut
>
> I think this will accomplish what you are trying to do.
I'm not even sure
> that subinterfaces will work on a 3548 as it is a layer
2 switch. Hope this
> helps
>
> Jim
>
> ---- RS wrote:
> > I want to create a mgmt vlan on vlan 5, however, I
read up here
> >
>
>
http://www.cisco.com/en/US/docs/switches/lan/catalyst290
0xl_3500xl/release12.0_5_wc_1_/swg/swgclust.html#wpxref32359
> > that this cannot be done on IOS versions prior to
12.0(5)XP.
> >
> > I have a simple setup of a 2811 connected via two
Fa ports to two Fa
> ports
> > on the 3548. Here is the setup:
> >
> >
> > Fa0/0 -- Fa0/3
> > 2811 3548
> > Fa0/1 -- Fa0/1
> >
> > 3548 Fa0/3 is a trunk supporting all active VLANs
and Fa0/0 is
> subinterfaced
> > to Fa0/0.001 and Fa0/0.005
> >
> > Fa0/0.001 has no IP and native vlan of 1
> > Fa0/0.005 has IP of 192.168.0.1 and native vlan of
5
> >
> > Vlan 1 has an IP of 192.168.10.2
> > Vlan 5 has an IP of 192.168.0.2
> >
> > I can reach 10.2 from the router but not 0.2
> >
> > I have switch the setup to Fa0/1 -- Fa0/3 and
still I can only reach
> 10.2.
> >
> > Any ideas?
> > Thanks,
> > Richard
Message Posted at:
http://www.groupstudy.com/form/read.php?f=7
&i=132232&t=132226
--------------------------------------------------
FAQ, list archives, and subscription info: http://www.
groupstudy.com/list/cisco.html
|