I had a similar lab where I could not use summary addresses,
default
commands. The requirement was to advertise my networks to
an
external neighbor, so I used the auto-summary. The result, I
sent
information about my class B network in its entirety to my
external neighbor
not allowing it to appear (in any form) in my routing table.
Since I do not know the scenario requirements I can only
suggest this as a
possible solution.
Regards,
Wayne
-----Original Message-----
From: nobody groupstudy.com [mailto:nobodygroupstudy.com] On Behalf
Of
Patrick Laidlaw
Sent: Sunday, April 09, 2006 4:18 PM
To: ciscogroupstudy.com
Subject: EIGRP Summarys [7:108737]
Hello,
I'm trying to figure out how to do a summary address for
eigrp without
including it in my own routers routing table.
So I have my R1 router sending a summary out its interfaces
fa0/0 and
s0/0 to two neighbor routers R2 and R3 but I need to keep
this summary
route out of my R1 routing table. Any ideas
Appreciate it.
Patrick Laidlaw
Message Posted at:
http://www.groupstudy.com/form/read.php?f=7
&i=108745&t=108737
--------------------------------------------------
FAQ, list archives, and subscription info: http://www.
groupstudy.com/list/cisco.html
|