no cdp snivel command needed

That command should be under the global config mode, not
interface
config mode

3750(config)#no cdp advertise-v2 ?
   

-----Original Message-----
From: nobodygroupstudy.com [mailto:nobodygroupstudy.com] On Behalf
Of
Marco van den Bovenkamp
Sent: Tuesday, May 30, 2006 3:09 PM
To: ciscogroupstudy.com
Subject: Re: no cdp snivel command needed [7:110532]

Marko Milivojevic wrote:

> 12.2(18)SXF:
> 
> D03-Bitruhals(config)#no cdp ?
>   advertise-v2  CDP sends version-2 advertisements
>   holdtime      Specify the holdtime (in sec) to be
sent in packets
>   run           Enable CDP
>   timer         Specify the rate at which CDP packets
are sent
(in 
> sec)
> 
> D03-Bitruhals(config)#int gi 5/2
> D03-Bitruhals(config-if)#no cdp ?
>   enable  Enable CDP on interface

I saw the same thing. Next try: 'no cdp advertise-v2'.
This will disable
the VLAN, VTP domain and Duplex TLVs. That may or may not be
a problem.

		Regards,

			Marco.
           ************** N O T I C E **************
The information contained in this transmission is intended
for the exclusive
use of the addressee(s) and may contain information that is
privileged,
confidential, and/or protected from disclosure.  If you are
not the intended
recipient, do not disseminate, distribute or copy this
communication.  If
you have received this transmission in error, please
immediately reply to
the  sender and then delete it.  Thank you for your
compliance.




Message Posted at:
http://www.groupstudy.com/form/read.php?f=7
&i=110569&t=110532
--------------------------------------------------
FAQ, list archives, and subscription info: http://www.
groupstudy.com/list/cisco.html