Re: Pertec interface

In article <001401c7443a$bd335b80$2101a8c0finans>,
    "Nico de Jong" <nicofarumdata.dk>  writes:

> From: "Al Kossow" <aekbitsavers.org>

> > Every Qualstar 1054 has a pertec-scsi bridge board
in it. Early ones
> > used NCR, later ones have their own design.
> >
> 
> The same is true for the 34xx series. This is a
Qualstar-developped board,
> so there might be some mounting problems etc. Would it
be relevant to put
> the data/documentation on bitsavers?

If you have documentation on them, then yes, please
contribute it to
bitsavers!

Al was just recently asking for this...
-- 
"The Direct3D Graphics Pipeline" -- DirectX 9
draft available for download
      <http://www.xmission.com/~legalize/book/download/in
dex.html>

        Legalize Adulthood! <http://blogs.
xmission.com/legalize/>

>
> In article <001401c7443a$bd335b80$2101a8c0finans>,
>     "Nico de Jong" <nicofarumdata.dk>  writes:
>
> > From: "Al Kossow" <aekbitsavers.org>
>
> > > Every Qualstar 1054 has a pertec-scsi bridge
board in it. Early ones
> > > used NCR, later ones have their own design.
> > >
> >
> > The same is true for the 34xx series. This is a
Qualstar-developped
board,
> > so there might be some mounting problems etc.
Would it be relevant to
put
> > the data/documentation on bitsavers?
>
> If you have documentation on them, then yes, please
contribute it to
> bitsavers!
>
I just found the diagram and the board layout. However, I
dont think my
scanner is good enough. How can we solve that problem?

Nico