Hi,
Not sure if this is the correct mail list to post this
question, please
excuse me if not.
I updated to the lateste devel-version of both
dynamips+dynagen ports
(emulators), and I can only get the ethernet virtual switch
to output
untagged frames out my interface. When using dot1q, no
frames are sent
over the wire.
The strange part is that freebsd tcpdump sees those dot1q
tagged
frames, but the interface (using bge) does not wire them. I
have
compiled the kernel with both bge and vlan support. FreeBSD
6.3.
Dynagen config:
[[ETHSW SW]]
0 = dot1q 1 NIO_gen_eth:bge0
Anyone have any idea of what might be wrong?
Thanks
____________________________________________________________
________________________
Be a better friend, newshound, and
know-it-all with Yahoo! Mobile. Try it now. http://mobile.yahoo.com/;_ylt=Ahu06i62sR8HDtDypao8Wcj9
tAcJ
_______________________________________________
freebsd-emulation freebsd.org mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-emu
lation
To unsubscribe, send any mail to
"freebsd-emulation-unsubscribefreebsd.org"
|