new to the list

I seem to be missing the mustek_usb2.conf file.   Downloaded

sane-backend-1.0.18 and installed.  No mustek_usb2.conf,
downloaded the 
latest mustek_usb2 file from the web site below and
installed.  No 
mustek_usb2.conf file.     If I understand correctly from
sane-usb(5) man 
page, I might be able to add "usb 0x0a53 0x5001"
in the .conf file and the 
backend might work?

Thanks,

James

----- Original Message ----- 
From: "Gerard Klaver" <gerardgkall.hobby.nl>
To: "James Newlin" <jnewlinmedmate.com>
Cc: <sane-devellists.alioth.debian.org>
Sent: Friday, September 22, 2006 11:38 AM
Subject: Re: [sane-devel] new to the list


> On Thu, 2006-09-21 at 16:37 -0400, James Newlin wrote:
>> Hello all,
>>
>> I'm looking into creating a backend/driver for a
EDT BizCardReader 900C 
>> USB
>> 2.0 card scanner.  It is using a SQ113C USB chip. 
The vendor ID is 0xA53
>> and device ID is 0x5001.   Any pointers or help
would be greatly
>> appreciated.  I do not know how much time I can
devote to the creation of
>> the new driver, but I am willing to try.  How would
I know if it needs to 
>> be
>> a low-level driver or not?
>>
>> Thanks,
>>
>> James
>>
>
> See this page,
> http://www.meier-geinitz.de/sane/mustek_usb2-backend/
>
> this backend uses the same chip accoording to this
page, the page is a
> bit old, the backend is already included in sane
1.0.18.
>
>
> -- 
> --------
> m.vr.gr.
> Gerard Klaver 

-- 
sane-devel mailing list: sane-devellists.alioth.debian.org
http://lists.alioth.debian.org/mailman/listinfo/sane-d
evel
Unsubscribe: Send mail with subject "unsubscribe
your_password"
             to sane-devel-requestlists.alioth.debian.org