Hi,
I am developing a USB stack on OHCI controller.The target
environment is
MPC5200B.
The code behaves properly and enumerates the LS
(Low-speed)devices
perfectly.I am able to communicate with the keyboard.
But if i plug in any FS/HS (Full-speed/High-speed) device I
get "device not
responding" error on get descriptor request . I tried
toggling the speed 'S'
bit in endpoint descriptor structure , but with no effect.
Can any body let me know what is the problem?
Regards
Siddharth
--
View this message in context: http://www.nabble.c
om/%22Device-not-responding%22-for-OHCI-controller-tf3187209
.html#a8846038
Sent from the OpenCores - USB mailing list archive at
Nabble.com.
_______________________________________________
http://
www.opencores.org/mailman/listinfo/usb
|
