Hello,
is there a way to set the 'User information layer 1
protocol' for the
SETUP message for 'Recommendation G.711 A-law (0x03)' ? If
yes, how can
I do that?
I have some issues with t38modem and a cisco gateway where
for the SETUP
containing 'User information layer 1 protocol:
Recommendation H.221 and
H.242 (0x05)' the Cisco responds with the same layer 1
protocol in
CONNECT message - while with another cisco I get G.711 A-law
(which
works well).
I would like to try whether I set another layer 1 protocol
will help or not.
Thank you in advance!
Regards,
Tamas
------------------------------------------------------------
------------
Check the FAQ before asking! - http://www.
openh323.org/~openh323/fom.cgi
The OpenH323 Project mailing list, using Mailman. To
unsubscribe or
change your subscription options, goto
htt
p://www.openh323.org/mailman/listinfo/openh323
Maintained by Quicknet Technologies, Inc - http://www.quicknet.net
------------------------------------------------------------
------------
|
