Hi Folks,
GDB supports "inferior" debugging, and when it's
enabled you get a lot
of additional output like:
> infrun: infwait_normal_state
> infrun: TARGET_WAITKIND_STOPPED
> infrun: stop_pc = 0x1284db1
> infrun: stepping inside range [0x1284d50-0x1284de0]
> infrun: resume (step=1, signal=0)
> infrun: prepare_to_wait
> infrun: infwait_normal_state
> infrun: TARGET_WAITKIND_STOPPED
> infrun: stop_pc = 0x1284db3
> infrun: stepping inside range [0x1284d50-0x1284de0]
> infrun: resume (step=1, signal=0)
> infrun: prepare_to_wait
> infrun: infwait_normal_state
For some reason, I can't shut this off in DDD. The gdb
command to
disable it is
set debug infrun 0
I can type this in at the (gdb) prompt in DDD, but it only
works until
the end of the current debug session. Then it comes right
back.
There is a DDD dialog for GDB Settings. It lists an option
for Inferior
Debugging. This is always set to "infrun" in the
dialog.
When I manually change it to zero to turn off inferior
debugging, and
click the Apply button it immediately changes back to
"infrun". If I
click the Close button instead, it remains 0, but only until
the end of
the debugging session.
I keep the "Save Options" toggle checked in DDD's
Edit menu. Whenever I
exit DDD, my ~/.ddd/init file says:
> set debug infrun "infrun"n
I can of course change it to zero in this file, but it is
overwritten by
DDD so this only works until the next time I exit DDD.
This does not seem to be a common problem. I'm using
ddd-3.3.9-1 on
CentOS 4.4, if it matters. I'm going to try manually
setting it to zero
in the init file and turning off "Save Options" to
see if that works.
Thanks for any pointers...
-dreq
|
