Re: how to not strip gnustep-base

Sebastian Reitenbach <sebastial00-bugdead-prods.de>
wrote: 
> Hi,
> 
> I try to compile gnustep-base-1.15.1 with
gnustep-make-2.0.2.
> I want to have debugging symbols installed and the
binaries not stripped, 
> therefore I ran 
> gmake messages=yes strip=no debug=yes install
> 
> but the binaries are stripped after install. The e.g.
defaults command is 
> not stripped, in the sources, but it is stripped after
it was installed in 
> the system.
> 
> Is there anything I can do to install it not stripped?
> 
> A file command on libgnustep-back tells me, it is not
stripped, but that 
is 
> afaik installed as a bundle. 
> 
> Any hint where I should take a look?
> grep -r strip * in the Makefiles unfortunately produces
a lot of hits.

I removed the -s in file
/usr/local/share/GNUstep/config.make where 
INSTALL_PROGRAM = install -c -s -m 555

without the -s there gnustep-base installed without
stripping the binaries.

I wonder whether the -s is correct in that place at all.

Sebastian



_______________________________________________
Discuss-gnustep mailing list
Discuss-gnustepgnu.org
http://lists.gnu.org/mailman/listinfo/discuss-gnustep

On Nov 24, 2007, at 8:55 AM, Sebastian Reitenbach wrote:
>
> I removed the -s in file
/usr/local/share/GNUstep/config.make where
> INSTALL_PROGRAM = install -c -s -m 555
>
> without the -s there gnustep-base installed without
stripping the  
> binaries.
>
> I wonder whether the -s is correct in that place at
all.
>
I don't see how that could get there unless INSTALL was
defined in  
the environment before you configured gnustep-make



_______________________________________________
Discuss-gnustep mailing list
Discuss-gnustepgnu.org
http://lists.gnu.org/mailman/listinfo/discuss-gnustep