LAM: editing laminfo information

Folks: 

I don't even know if it's necessary, but when I run the laminfo command after the 7.1.3 installation, I get some erroneous information in the output.  I am assuming that this information is coming from a configuration file that is text edited, but that may be ignorance on my part. 

Forgive me for such a trivial question, but I'm just beginning to work with LAM-MPI.  

Thanks in advance. 

Noah W. Allen, III

Assistant Professor of Chemistry 

University of North Carolina Asheville

Department of Chemistry, CPO 2310

Office 208A Rhoades Hall

The Allen Laboratory, Principal Investigator

Research Laboratory 211 Rhoades Hall 

One University Heights 

Asheville, North Carolina 28804-8511

Phone 828.232.5174

Fax 828.232.5179 

Email:  nallenunca.edu">nallenunca.edu

Homepage:  http://www.theallenlab.org 

AIM or Mac.Com messenger: theallenlab