I'm trying to get a M10 to work in transparent mode. I am
starting from
scratch with a complete reinstall, updating the firmware to
v3.10 I got it
working once but could not get back into the management
console after I did.
I think I used the wrong value for management IP address. I
set it to an IP
in the subnet I'm trying deploy it on but it didn't work. I
have found the
documentation to be very vague, this appliance was dropped
on my desk over a
year ago to try and figure out and I lost patience with it
but have been
told to give it another shot for use at our other location.
Any help is much appreciated
Michael
_______________________________________________
ISSForum mailing list
ISSForum atla-mm1.iss.net
TO UNSUBSCRIBE OR CHANGE YOUR SUBSCRIPTION, go to ht
tps://atla-mm1.iss.net/mailman/listinfo/issforum
To contact the ISSForum Moderator, send email to
mod-issforumiss.net
The ISSForum mailing list is hosted and managed by Internet
Security Systems, 6303 Barfield Road, Atlanta, Georgia, USA
30328.
|