Re: help in using my downloaded libraries

Thanks, that's what I was overlooking. I was just looking in the help
for pcbnew, I did not think about looking in CVPCB, my bad. It's so
simple to use I don't spend much time in CVPCB. All and all I'm really
happy with KiCad and hopefully when I get more experience under my
belt I can contribute more. I'm a pretty good C++ coder. I've had good
luck with sending the files to board houses and doing my own
photoetching. Just finishing my my first really complicated board
design and trying to figure out the whole hierarchical, sub-sheet, pin
sheet thing.

--- In kicad-users%40yahoogroups.com">kicad-usersyahoogroups.com, "Danilo Uccelli&quot; <danucc...> wrote:
&gt;
> Dear deaninkc,
>
> You write :"The ones I downloaded are .mod files and they still
don't show
>; up."
>
> Do you have add the module library file as explained on the part 4.3
of the
> CVPCB help ?
>
> If you still not have access to the library probably there is a
problem with
>; your installation.
>
> The .mdc file is automaticaly generated, I don't know exactly his
function
> but you don't need it when you install a new library.
>
> HTH
>
> --
> Danilo Uccelli
> CH-2400 Le Locle
&gt; danucc...
>

Messages in this topic (13) Reply (via web post) | Start a new topic

.