V3 question - Statistics Descriptor in Modify

Hello Dani,

Section 7.2.2 Mod isn't exactly silent , it says:
"The remaining 
parameters to Modify are the same as those to Add. Possible
return 
values are the same as those to Add."

In documenting Mod and Mov rather than re-specifying
everything that was 
in ADD we simply referred back to it.

Regards, Christian

Dani Stettiner wrote:
>
> Hi All
>
> Version 3 had set the ability to add statistics
descriptor in Add command:
>
> 7.2.1 Add
>
> ......................
>
> The Statistics Descriptor is optional. If present, it
provides the 
> statistics which the MGC wishes to
>
> be collected for the termination or stream. Each time
the statistic is 
> set, the statistic value is reset.
>
> ....................
>
> Obviously the text above: “Each time the statistic is
set, the 
> statistic value is reset” is more appropriate for
Modify command
>
> (In Add it is meaningless since no statistics were
accumulated yet)
>
> Although the grammar allows statistics descriptor for
Modify (as well 
> as other commands), Section 7.2.2 (modify) is silent
about it.
>
> Would it be right to assume the text “Each time the
statistic is set, 
> the statistic value is reset” is valid also for Modify
and Move?
>
> Regards
>
> //Dan Stettiner///
> ///Software Engineer, R&D//
> //H.248/MEGACO ///
>
> /Audiocodes
> Email: dani.stettineraudiocodes.com 
> <mailto:dani.stettineraudiocodes.com>
> Tel. +972-3-9764415
> www.audiocodes.com <http://www.audiocodes.com/ohttp:/www.audiocodes.com/>

>
>
------------------------------------------------------------
------------
>
> _______________________________________________
> Megaco mailing list
> Megacoietf.org
> https:/
/www1.ietf.org/mailman/listinfo/megaco
>   


_______________________________________________
Megaco mailing list
Megacoietf.org
https:/
/www1.ietf.org/mailman/listinfo/megaco