AR5006: ath0: unable to attach hardware; HAL status 13

Hi,

I installed a recently bought Mini PCI Express card
Gigabyte GN-WI01GT (based on Atheros 5006 as described
by the seller) in Averatec 2260 YI-1 notebook. The
kernel (6.2 stable GENERIC) sees the card as AR 5424.

>From dmesg:

ath_hal: 0.9.17.2 (AR5210, AR5211, AR5212, RF5111,
RF5112, RF2413, RF5413)
ath0: <Atheros 5424> mem 0xfebf0000-0xfebfffff irq 16
at device 0.0 on pci6
ath0: unable to attach hardware; HAL status 13
device_attach: ath0 attach returned 6

>From pciconf -lv :

ath0pci6:0:0:  class=0x020000 card=0xe9131458
chip=0x001c168c rev=0x01 hdr=0x00
    vendor   = 'Atheros Communications Inc.'
    class    = network
    subclass = ethernet


Any help would be greatly appreciated.

Thanks,
Andrew



 
____________________________________________________________
________________________
Never Miss an Email
Stay connected with Yahoo! Mail on your mobile.  Get
started!
http://
mobile.yahoo.com/services?promote=mail
_______________________________________________
freebsd-mobilefreebsd.org mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-mobile

To unsubscribe, send any mail to
"freebsd-mobile-unsubscribefreebsd.org"

Andrew Terekhov wrote:
> Hi,
> 
> I installed a recently bought Mini PCI Express card
> Gigabyte GN-WI01GT (based on Atheros 5006 as described
> by the seller) in Averatec 2260 YI-1 notebook. The
> kernel (6.2 stable GENERIC) sees the card as AR 5424.
> 
>>From dmesg:
> 
> ath_hal: 0.9.17.2 (AR5210, AR5211, AR5212, RF5111,
> RF5112, RF2413, RF5413)
> ath0: <Atheros 5424> mem 0xfebf0000-0xfebfffff
irq 16
> at device 0.0 on pci6
> ath0: unable to attach hardware; HAL status 13
> device_attach: ath0 attach returned 6
> 
>>From pciconf -lv :
> 
> ath0pci6:0:0:  class=0x020000 card=0xe9131458
> chip=0x001c168c rev=0x01 hdr=0x00
>     vendor   = 'Atheros Communications Inc.'
>     class    = network
>     subclass = ethernet
> 
> 
> Any help would be greatly appreciated.

I think this is a b/g only card, right?  If so you need the
hal in HEAD
that I've been too busy to MFC.  Unfortunately bringing the
hal back to
6.x involves some driver mods too (if I recall) so you can't
just copy
the bits.

	Sam
_______________________________________________
freebsd-mobilefreebsd.org mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-mobile

To unsubscribe, send any mail to
"freebsd-mobile-unsubscribefreebsd.org"