Deploy to tarball

Thanks for the response Scott, I will get latest from SVN
tonight when I
get home and try again.  I have set my runtime options in
the project
settings, so everything is OK on that side.  I'm looking
forward to
it!!



> -------- Original Message --------
> Subject: Re: [MonoDevelop] Deploy to tarball
> From: Scott Ellington <scottell.listsgmail.com>
> Date: Fri, August 18, 2006 6:41 am
> To: "Carlos J. Muentes" <carlosrockwithme.org>
> Cc: monodevelop-list <monodevelop-listlists.ximian.com>
> 
> Hi,
> 
> I'd forgotten about this, but it appears Lluis added
this functionality
> about a month ago:
> 
> http://svn.myrealbox.com/viewcv
s/trunk/monodevelop/Extras/CSharpBinding/Autotools/CSharpAut
otoolsSetup.cs?rev=62683&r1=61764&r2=62683
> 
> I was able to create a test solution which uses
Generics, generate
> autotools, and build with make successfully.  Make sure
you are using an
> updated SVN and that you have set your project to the
2.0 runtime.
> 
> Scott
> 
> On Fri, 2006-08-18 at 00:33 -0400, Carlos J. Muentes
wrote:
> > Hey all,
> > 
> >     I added a tarball deployment target to a
project I built in
> > MD.  ./configure runs fine, but make fails with a
parsing error (due
> > to generics).  The project targets the 2.0 runtime
(and compiles and
> > runs fine in MD), but the tarball doesn't seem to
be configured to
> > compile against the 2.0 runtime.  What am I
missing? 
> > _______________________________________________
> > Monodevelop-list mailing list
> > Monodevelop-listlists.ximian.com
> > http://lists.ximian.com/mailman/listinfo/monodevelop-li
st

_______________________________________________
Monodevelop-list mailing list
Monodevelop-listlists.ximian.com
http://lists.ximian.com/mailman/listinfo/monodevelop-li
st