-current boot failure on sparc64

Heyas folks --

I dusted off my old Ultra5 and went to fire up -current. No
luck -- the 
latest INSTALL kernels hang after you select a keyboard
type. So I 
installed the latest 4.0 snapshot, built a -current GENERIC
kernel, and 
booted -- same hang, where I would normally expect to see
the 'Setting tty 
flags.' message.

Btw, I'm using a keyboard/mouse and machfb console.

Any ideas?

Cheers,
Jared

On Fri, Mar 30, 2007 at 03:46:56PM -0400, Jared D. McNeill
wrote:
> Any ideas?

Yeah, an old bug uncovered by the newlock2 changes - if you
add DEBUG
to your kernel, it will probably work.

I'll commit a fix within the next few hours.

Martin

On Fri, 30 Mar 2007, Martin Husemann wrote:
> On Fri, Mar 30, 2007 at 03:46:56PM -0400, Jared D.
McNeill wrote:
>> Any ideas?
>
> Yeah, an old bug uncovered by the newlock2 changes - if
you add DEBUG
> to your kernel, it will probably work.
>
> I'll commit a fix within the next few hours.

Cool, thanks. mgr suggested I add LOCKDEBUG and everything
seems to be 
fine for now.

Cheers,
Jared

> Cool, thanks. mgr suggested I add LOCKDEBUG and
everything seems to be
> fine for now.

Erm, that was mrg, not mgr -- my bad 

Cheers,
Jared