Jan Danielsson <jan.danielsson gmail.com> writes:
> When I insert my USB memorystick, I get a message on
the console
> which states that something has happened with sd0, so I
was expecting
> something from the card reader too.
>
> Anyway, could you run:
>
> # usbdevs -v
>
> ...and post the results?
Controller /dev/usb0:
addr 1: full speed, self powered, config 1, OHCI root
hub(0x0000), ATI Technologie(0x1002), rev 1.00
port 1 powered
port 2 addr 2: full speed, self powered, config 1, PSC
1500 series(0x4c11), HP(0x03f0), rev 1.00
port 3 powered
port 4 addr 3: full speed, power 100 mA, config 1, USB
Reader(0x9360), Alcor Micro(0x058f), rev 1.00
ontroller /dev/usb1:
ddr 1: full speed, self powered, config 1, OHCI root
hub(0x0000), ATI Technologie(0x1002), rev 1.00
port 1 addr 2: low speed, power 24 mA, config 1, Back-UPS
BR 800 FW:9.o2 .D USB FW:o2(0x0002), American Power
Conversion(0x051d), rev 1.06
> It seems that my NetBSD system doesn't even see the
card reader.
Here's an extract from my boot messages:
umass0 at uhub0 port 4 configuration 1 interface 0
umass0: Alcor Micro USB Reader, rev 1.10/1.00, addr 2
umass0: using SCSI over Bulk-Only
scsibus0 at umass0: 2 targets, 4 luns per target
sd0 at scsibus0 target 0 lun 0: <Generic, USB SD
Reader, 1.00> disk removable
sd0: drive offline
sd1 at scsibus0 target 0 lun 1: <Generic, USB CF
Reader, 1.01> disk removable
sd1: drive offline
sd2 at scsibus0 target 0 lun 2: <Generic, USB SM
Reader, 1.02> disk removable
sd2: drive offline
sd3 at scsibus0 target 0 lun 3: <Generic, USB MS
Reader, 1.03> disk removable
sd3: drive offline
>> I just mount and unmount mine manually as needed.
Here's an extract
>> from my fstab file:
> [---]
>
> Doesn't work here. :-(
>
> mount: cannot open `/dev/sd0e`: Device not configured
> mount: cannot open `/dev/sd1e`: Device not configured
Huh. I hope the boot message above turn out to be helpful.
Anne.
--
Ms. Anne Bennett, as a private citizen: anne porcupine.montreal.qc.ca
Also reachable more officially at work: anne encs.concordia.ca
|