Pencentra 200?

Hi all (again).

> Hi All.
> I'm an owner of a Pencentra 200.
> Its microprocessor is a 129MHz Toshiba(R) TX3922 MIPS
RISC CPU.
>
> So i've prepared a CF with :
> netbsd-GENERIC.gz (renamed an ungzipped)
> [ A gzipped NetBSD kernel containing code
>
>  for everything supported in this
>  release. This kernel runs on Vr41xx
>  and TX3922 CPUs only.
> from :
>
ftp://ftp.netbsd.org/pub/NetBSD/NetBSD-3.1/hpcmips/INSTALL.t
xt
> ]
> and
> pbsdboot.exe
>
> I have no problem to start pbsdboot.exe (using
Oencentra 130 framebuffer
> profile), but i have this error:
> "Error: mapping interrupt vector failed".
>
> I know that it's a known problem (
> http://article.gmane.org/gmane.os.net
bsd.ports.hpcmips/2069/match=pencentra),
> but is there a solution??

Anyone has tried the netbsd 4.0 on pencentra 200?
Any tips?

Regards
M

Hi Risto!

>  The GENERIC kernel from 4.0 does not boot, but we have
now fixed the problem
>  in -current compiling with i.e. TX3922, I could send
you a kernel
>  (again , if you do
not like to set up a cross-compilation environment. I
>  recall, that last time you had problems to boot the
kernel I sent you, was
>  it about the size of the mainmemory??

(i remember too!)

My Pencentra 200 has 32 MB of Ram memory.
I'll accept "your" kernel, if you'll send me :-D.
Thanks in advance!

King regards!
M