Mirco Piccin wrote:
> Hi all (again).
>
>> Hi All.
>> I'm an owner of a Pencentra 200.
>> Its microprocessor is a 129MHz Toshiba(R) TX3922
MIPS RISC CPU.
>>
>> So i've prepared a CF with :
>> netbsd-GENERIC.gz (renamed an ungzipped)
>> [ A gzipped NetBSD kernel containing code
>>
>> for everything supported in this
>> release. This kernel runs on Vr41xx
>> and TX3922 CPUs only.
>> from :
>>
ftp://ftp.netbsd.org/pub/NetBSD/NetBSD-3.1/hpcmips/INSTALL.t
xt
>> ]
>> and
>> pbsdboot.exe
>>
>> I have no problem to start pbsdboot.exe (using
Oencentra 130 framebuffer
>> profile), but i have this error:
>> "Error: mapping interrupt vector
failed".
>>
>> I know that it's a known problem (
>>
http://article.gmane.org/gmane.os.net
bsd.ports.hpcmips/2069/match=pencentra),
>> but is there a solution??
>
> Anyone has tried the netbsd 4.0 on pencentra 200?
> Any tips?
>
> Regards
> M
Hi Mirco
The GENERIC kernel from 4.0 does not boot, but we have now
fixed the problem
in -current compiling with i.e. TX3922, I could send you a
kernel
(again  , if you do
not like to set up a cross-compilation environment. I
recall, that last time you had problems to boot the kernel I
sent you, was
it about the size of the mainmemory??
risto
|
