-----BEGIN PGP SIGNED MESSAGE-----
Hash: SHA1
So I'm lazy. Or stupid. Or both. I did try to follow the
instructions
previously pointed at for how to configure RAIDframe with
grub and
xen but I messed it up somehow. And on another box I
installed
RAIDframe (w/o grub or xen) only to have it run fine, but
always come
up with dirty parity after a reboot. Haven't figured out why
yet
(suggestions?). So I'm clearly not up to speed on RAIDframe
yet.
And as I'm short on time and also interested in hot-swap
(this will
be a remote box where the ability to use remote hands to
swap disks
on a running system would be really great) I'm contemplating
my first
hardware RAID ever.
The system has 4 x SATA disks and I'm looking at either
* Adaptec 2410SA (supported by aac(4))
or
* 3ware Escalade 9500S-4LP (supported by twa(4) or twe(4),
although
looking again that seems less than clear)
Any recommendations? Any concerns?
Johan
-----BEGIN PGP SIGNATURE-----
Version: GnuPG v1.4.5 (Darwin)
iD8DBQFFx9qnKJmr+nqSTbYRAhfgAJ9iC+SmtmMOb1Y4r1Zjw6LrdFd/lwCd
Gfqb
+mk6CgKqMXU74XqXN2t1S5Q=
=7RiF
-----END PGP SIGNATURE-----
|
