Brownells in Iowa/ USA carries special gun screw drivers w/ parallel side tips so you don't mess up the slotted screw head. They also sell a fixture that allows you to grind a driver narrower or slimmer. Check them out on the web.
Bill
"C.J. Scheppers" < cscheppers%40kc.rr.com">cscheppers
kc.rr.com> wrote:
Thanks for the "tip" on JIS screwdrivers.
Is there a special set of screwdrivers for slotted screw heads? I've
seen screws which have narrower slots for their width; Wiha flat tip
screwdrivers which fit the slot are not wide enough to engage the
entire slot.
C.J.
>In a message dated 10/9/2007 10:46:09 AM Eastern Daylight Time,
><mailto:slowhands95128%40yahoo.com>; slowhands95128%40yahoo.com">slowhands95128yahoo.com writes:
>
>Micro tools
>has them, but the quality is not quite as good as the Hozan tools I
>found here (set D-27 is good):
><;http://www.ikaswebshop.com/jisphilips.html>http://www.ikaswebshop.com/jisphilips.html
>
>00000000000000000000
>
>Hello slowhands
>Are WIHA screwdrivers comparable, the same, ??
>Your opinion welcome
>David Gaon
[Non-text portions of this message have been removed]
---------------------------------
Moody friends. Drama queens. Your life? Nope! - their life, your story.
Play Sims Stories at Yahoo! Games.
[Non-text portions of this message have been removed]
