SPR/532 (new firmware) not detected by OpenCT udev rules

(just for completeness)

Hello,

I just found out that (after a firmware upgrade) my SPR/532
(Chipdrive pinpad
USB)
is not longer recognized by UDEV.
The standard rule in 50-openct.conf says:
# spr 532 - ccid, but with wrong interface class (vendor)
:(
SYSFS=="04e6",
SYSFS=="0003",
RUN+="/lib/udev/openct_usb"

udev reports that the reader uses a productId of
"e003" instead of the former
"0003":
#spr532 by martin
SYSFS=="04e6",
SYSFS=="e003",
RUN+="/lib/udev/openct_usb"

After that modification it works fine.

Best regards,

Martin

_______________________________________________
opensc-user mailing list
opensc-userlists.opensc-project.org
http://www.opensc-project.org/mailman/listinfo/opensc-
user

On 18.10.2007, at 0:41, martin h wrote:

> I just found out that (after a firmware upgrade) my
SPR/532  
> (Chipdrive pinpad
What version of the firmware ?

m.
-- 
Martin Paljak
http://martin.paljak.pri.
ee
+3725156495


_______________________________________________
opensc-user mailing list
opensc-userlists.opensc-project.org
http://www.opensc-project.org/mailman/listinfo/opensc-
user

2007/10/18, Martin Paljak <martinpaljak.pri.ee>:
>
> On 18.10.2007, at 0:41, martin h wrote:
>
> > I just found out that (after a firmware upgrade)
my SPR/532
> > (Chipdrive pinpad
> What version of the firmware ?

I always had this product ID 0xE003 for my SPR532 with
firmware 4.15
[1] or 5.10 [2].

bye

[1] http://sv
n.debian.org/wsvn/pcsclite/trunk/Drivers/ccid/readers/SPR532
.txt?op=file&rev=1282&sc=0
[2] http://sv
n.debian.org/wsvn/pcsclite/trunk/Drivers/ccid/readers/SPR532
.txt?op=file&rev=2047&sc=0

-- 
 Dr. Ludovic Rousseau
_______________________________________________
opensc-user mailing list
opensc-userlists.opensc-project.org
http://www.opensc-project.org/mailman/listinfo/opensc-
user

Am Donnerstag, den 18.10.2007, 11:08 +0300 schrieb Martin
Paljak:
> On 18.10.2007, at 0:41, martin h wrote:
> 
> > I just found out that (after a firmware upgrade)
my SPR/532  
> > (Chipdrive pinpad
> What version of the firmware ?
Currently it has version 5.10
I just noticed this on Ubuntu 7. It possibly affects both
firmwares
(IMHO there are only 2 versions). I remember, it worked with
the older
firmware, too. But this wasn't udev but HAL. 

I posted this because this mailing list is the first place
to look.

Martin

_______________________________________________
opensc-user mailing list
opensc-userlists.opensc-project.org
http://www.opensc-project.org/mailman/listinfo/opensc-
user