WinCE Restoration failed

Hi there,

I attempted to do a WinCE restoration using the CF Card
sleeve on my iPaq H3600.
After finally finding an H3600 Pocket PC image that wouldn't
fail the
integrity check from the bootloader during the initial stage
of the
flash procedure, this image seemed to work right through to
the end of
the "programming" stage of the flash.  The
instructions on the
handhelds.org wiki
(
http://handhelds.org/moin/moin.cgi/RestoringPocketPc) 
state that at
the end of the procedure, to press the joypad to restart. 
However at
the end of the procedure with my machine, the screen simply
blanked
and I saw no message to state that it was finished.  Now
when I try to
boot it, it simply loads the Linux ARM Bootloader 2.21.12
but if I
press the "Q" button to load from vfat, it simply
reboots into the
bootloader screen.

Is there anything I can do now to correct this?

Thanks,

Dale Stewart
_______________________________________________
Open Source Software for Compaq iPAQ Handhelds.
iPAQ mailing list
iPAQhandhelds.org
https://h
andhelds.org/mailman/listinfo/ipaq
irc://irc.openprojects.net #ipaq