Good day,
My question si how can i write (eg install) CRL bootloader
from the
original Compaq bootloader? (also known as Parrot bootloader
and i think
OSloader), i have an 3760 witch had wince and
parrotbootloader, i
installed linux and crl bootloader and then after one week i
needed
wince back 4 personal reasons, I restored the wince image
and the parrot
bootloader, but now it doesn't boot wince anymore.
My cradle was a USB only but i've converted it to serial
too.
I've tried openjtag software with an non buffered cable, i
can see the
ARM processor on the chain but i can't detect the flash
memory, and as i
read in some forums there might be a problem writing to the
flash since
it's organised as 1x32bit.
I have an electronics degree and now i attend computer
science
university, but my programming skills are in theyr infancy.
Can u help me or at list direct me to someone who can help
me ?
Thank u very much,
Buda Razvan
_______________________________________________
Open Source Software for Compaq iPAQ Handhelds.
iPAQ mailing list
iPAQ handhelds.org
https://h
andhelds.org/mailman/listinfo/ipaq
irc://irc.openprojects.net #ipaq
|
