Re: bootldr frozen, do I have a brick?

Gavin,

I suggest you ask this question on h4700-port

Marcus.

Gavin Power wrote:
> Hi there,
> When using Bootblaster most versions I downloaded (and
transfered via 
> ActiveSync) would only start for a brief second. I
finally found 
> BootBlaster_1.8.exe to run fine. I have a HX4700 so I
chose 
> bootldr-sa-2.20.4.bin to load as my bootldr. I selected
it on the list 
> and it began programming the flash. An error message
appeared stating 
> something like "cannot configure network".
After waiting a few minutes 
> the device was still frozen with the error message
still showing. I 
> turned it off and now it will not turn back on again.
>  
> If this is unfixable can I get some advice on getting
HP to re-flash 
> this for me. Will leaving the device turned off for a
while help?
>  
> Much help please.
> Regards
> Gavin.
>  

_______________________________________________
Open Source Software for Compaq iPAQ Handhelds.
iPAQ mailing list
iPAQhandhelds.org
https://h
andhelds.org/mailman/listinfo/ipaq
irc://irc.openprojects.net #ipaq