Re: trying to configure XAUTH as replacement for working Cisco VPN C

Marcus

The fellow who had built 2.4.8rc1 for 'openwrt' has not
offered 
to share his code, and I don't have time to dedicated to
the
cross-compile and integration effort, especially as the
Cisco VPN 
Client works fine.  So haven't tried it.  Guess we have to 
wait for the next version of 'openwrt', which could be many

months out.  Apparently a Linux version of the Cisco client

exists, and I many try to obtain a copy of that.

David



At 11:36 AM 4/5/2007 +0200, Marcus Carlson wrote:
>Hi,
>
>Did you successfully connect to cisco using groupname
using 2.4.8rc1? 
>And what config settings did you use? I've tried the
same as you wrote 
>but received different errors.
>
>Regards,
>Marcus
>
>David Lawless wrote:
>> Hello,
>>
>>
>> Here's the config.  I've been using the commented
lines in the
>> second case above.
>>
>> version 2.0
>> config setup
>>         interfaces=%defaultroute
>>         nat_traversal=yes
>>         klipsdebug=none
>>         plutodebug=none
>>
>> conn Connection
>>         left=             %defaultroute
>>         leftid=           GroupName
>>         leftxauthclient=  yes
>>         right=            R.R.R.R
>>         rightsubnet=      R.R.R.H/32
>>         rightxauthserver= yes
>>        #aggrmode=         yes
>>        #ike=              aes128
>>        #esp=              3des-sha1-96
>>         authby=           secret
>>         xauth=            yes
>>         auto=             add
>>
>>

_______________________________________________
Dev mailing list
Devopenswan.org
http:/
/lists.openswan.org/mailman/listinfo/dev