> Harold:, Do you really recopy the replies that you
quote? I suspect so
because you misspelled "plugged" where I was
quoted below.
> You can copy the item to be quoted by sweeping over it
with the left mouse
button depressed. Then hit control-"C'. Position the
mouse cursor where you
want the quote to appear in your message and with no buttons
depressed, hit
control-"V". If you do not like using the
keyboard, you can find "copy" and
"paste" with the right mouse button. --- Wally
Remember, I get the digest frrm of PCWorks, so just clicking
"Reply" requires
some changes (which is what I sometimes do). Somehow your
"plugged" became
"lugged" ... it probably slipped off the
clipboard. I'll make all kinds of
changes in replies if I think it will be easier for the
reader. I usually give
a particular part of a reply a Ctrl+C sweep, sometimes even
put it through
eCleaner to remove any any special formatting or html
symbols, brackets, etc.
And sometimes (not often), put it throuth MSWord if I think
the line spaces
are not looking right. Finally I'll Ctrl+V it into the
email page. What I'm
really trying to do is get the replies to look as neat on
the page as
possible. I try, can't always succeed, to avoid the
following look:
> FROM WALLY: Harold, evidently you are leaving your
flash drive
> plugged in all
> the time. If you remove it when the icon says it is
"safe to remove
> hardware"
> (when the flash drive is not being accessed), the icon
will go away.
> ---
> Wally
Btw, "plugged" looks all right to me, Wally 
============= PCWorks Mailing List =================
Don't see your post? Check our posting guidelines &
make sure you've followed proper posting procedures,
http://pcworkers.com/r
ules.htm
Contact list owner <owner-pcworks imagicomm.com>
Unsubscribing and other changes: http://pcworkers.com
=====================================================
|