Re: Newbie with a 7200 development kit - CF boot failure

Romain

Thank you - I'll try this a little later today.

--- In ts-7000%40yahoogroups.com">ts-7000yahoogroups.com, "bowbaq74000&quot; <bowbaq74000...> wrote:
&gt;
> Hi,
>
> To boot from the CFCard, you must change the RedBoot configuration.
> To do that, you reboot your card and type "CTRL+C"; when RedBoot
start
> (when the '+' appear).
> After you must use the command : fconfig, then type :
> >> fis load vmlinux
> >> exec -c "console=ttyAM0,115200 root=/dev/hda1"
>
> Regards,
> Romain
&gt;
>
> --- In ts-7000%40yahoogroups.com">ts-7000yahoogroups.com, "benoit.steve&quot; <benoit.steve>
> wrote:
&gt; >
>; > Hi
> >
> > I have a 7200 with a dev kit and the 512Mb CF flash card w/Linux
on
> it
> >
> > How do I boot from the CF card?
&gt; >
> > board boots into the onboard BusyBox linux fine.
&gt; >
> > with the cf card installed, I get the error "failed to identify
> unit 0" error msg and teh system
> > proceeds through to regualr onboard boot
>; >
> > without the cf card - system boots to busybox
> >
> > thanks
&gt; >
> > steve
&gt; >
>;

Messages in this topic (0) Reply (via web post) | Start a new topic

.

thank you - it workedd fine

--- In ts-7000%40yahoogroups.com">ts-7000yahoogroups.com, "benoit.steve&quot; <benoit.steve...> wrote:
&gt;
> Romain
>
> Thank you - I'll try this a little later today.
&gt;
>
> --- In ts-7000%40yahoogroups.com">ts-7000yahoogroups.com, "bowbaq74000&quot; <bowbaq74000> wrote:
&gt; >
>; > Hi,
> >
> > To boot from the CFCard, you must change the RedBoot configuration.
> > To do that, you reboot your card and type "CTRL+C"; when RedBoot
> start
> > (when the '+' appear).
> > After you must use the command : fconfig, then type :
> > >> fis load vmlinux
> > >> exec -c "console=ttyAM0,115200 root=/dev/hda1"
> >
> > Regards,
> > Romain
&gt; >
> >
> > --- In ts-7000%40yahoogroups.com">ts-7000yahoogroups.com, "benoit.steve&quot; <benoit.steve>
> > wrote:
&gt; > >
>; > > Hi
> > >
> > > I have a 7200 with a dev kit and the 512Mb CF flash card w/Linux
> on
> > it
> > >
> > > How do I boot from the CF card?
&gt; > >
> > > board boots into the onboard BusyBox linux fine.
&gt; > >
> > > with the cf card installed, I get the error "failed to identify
> > unit 0" error msg and teh system
> > > proceeds through to regualr onboard boot
>; > >
> > > without the cf card - system boots to busybox
> > >
> > > thanks
&gt; > >
> > > steve
&gt; > >
>; >
>;

Messages in this topic (0) Reply (via web post) | Start a new topic

.