Re: Re: rs232 bash acquisition

> another question : com3 corrispond to ttyS2 ?
> is active directly or i must load the module tsuart7800?

http://oz.embeddedarm.com/~michael/support/ts7800.html#uart

COM3 is TS-UART #4. After loading tsuart1 and tsuart7800 it should show up
at /dev/ttts4. (You may need to run a command to make it show up (e.g.
mdev -s) if udev isn't running...)

______ Best Regards,
|__ __/ Michael Schmidt
|| Software Engineer
||echnologic Systems (EmbeddedARM.com)
|| (480) 16610 East Laser Drive #10
|/ 837-5200 Fountain Hills, AZ 85268
http://oz.embeddedarm.com/~michael

Messages in this topic (8) Reply (via web post) | Start a new topic

.

how i can do this ?
You may need to run a command to make it show up (e.g.
mdev -s) if udev isn't running...)
how i can run udev ?
wich sintax ?
i ve loaded the two module tsuart1 and tsuart7800 and all ok if i
digit lsmod i se them i hope u write me back soon
--- In ts-7000%40yahoogroups.com">ts-7000yahoogroups.com, "Michael" <michael...> wrote:
&gt;
> > another question : com3 corrispond to ttyS2 ?
> > is active directly or i must load the module tsuart7800?
>
>
> http://oz.embeddedarm.com/~michael/support/ts7800.html#uart
>
> COM3 is TS-UART #4. After loading tsuart1 and tsuart7800 it should
show up
> at /dev/ttts4. (You may need to run a command to make it show up (e.g.
> mdev -s) if udev isn't running...)
>
> ______ Best Regards,
> |__ __/ Michael Schmidt
> || Software Engineer
> ||echnologic Systems (EmbeddedARM.com)
> || (480) 16610 East Laser Drive #10
> |/ 837-5200 Fountain Hills, AZ 85268
&gt; http://oz.embeddedarm.com/~michael
>

Messages in this topic (9) Reply (via web post) | Start a new topic

.