Re: Re: rs232 bash acquisition

> how i can do this ?
> You may need to run a command to make it show up (e.g.
> mdev -s) if udev isn't running...)
> how i can run udev ?
> wich sintax ?
> i ve loaded the two module tsuart1 and tsuart7800 and all ok if i
> digit lsmod i se them i hope u write me back soon

Do you see /dev/ttts* files? If so then you should be good to go... if not,
then run "mdev -s" and that should populate the files.

______ Best Regards,
|__ __/ Michael Schmidt
|| Software Engineer
||echnologic Systems (EmbeddedARM.com)
|| (480) 16610 East Laser Drive #10
|/ 837-5200 Fountain Hills, AZ 85268
http://oz.embeddedarm.com/~michael

Messages in this topic (11) Reply (via web post) | Start a new topic

.

yes i see under dev directory ttts* peripheral but if i launch
stty -F /dev/ttts4 9600
stty: /dev/ttts4: No such device or address
or
stty -F /dev/ttyS4 9600
stty: /dev/ttyS4: Input/output error

whats wrong ?

rootts7800:/# stty -F /dev/ttts4 9600
stty: /dev/ttts4: No such device or address

--- In ts-7000%40yahoogroups.com">ts-7000yahoogroups.com, "Michael" <michael...> wrote:
&gt;
> > how i can do this ?
> > You may need to run a command to make it show up (e.g.
&gt; > mdev -s) if udev isn't running...)
> > how i can run udev ?
> > wich sintax ?
> > i ve loaded the two module tsuart1 and tsuart7800 and all ok if i
> > digit lsmod i se them i hope u write me back soon
>;
> Do you see /dev/ttts* files? If so then you should be good to go...
if not,
> then run "mdev -s" and that should populate the files.
&gt;
>
> ______ Best Regards,
> |__ __/ Michael Schmidt
> || Software Engineer
> ||echnologic Systems (EmbeddedARM.com)
> || (480) 16610 East Laser Drive #10
> |/ 837-5200 Fountain Hills, AZ 85268
&gt; http://oz.embeddedarm.com/~michael
>

Messages in this topic (12) Reply (via web post) | Start a new topic

.