any mars edit users working off trunk?

Hi folks,

I upgraded gridengine.info to trunk last week from a stable
yet  
really ancient base version. The upgrade went very smoothly
but I  
just noticed some issues when posting articles using Mars
Edit 1.1.2.

The symptoms are as follows:

- post goes through fine, xmlrpc console shows no errors
- article summary shows up on the main page
- clicking on the article header to go to the full pieces
produces a  
polite "article can't be found" error
- clicking on a tag (if it is new) will show a polite
"tag does not  
exist" error
- article does not show up in category view or tag view

Once I login to Typo, select 'edit' and then 'save'
everything is  
created and works fine.

Anyone else see this with external tools? Posting that
partially  
works? My SVN info says Revision: 1053

Regards,
Chris




_______________________________________________
Typo-list mailing list
Typo-listrubyforge.org
http:
//rubyforge.org/mailman/listinfo/typo-list

-----BEGIN PGP SIGNED MESSAGE-----
Hash: SHA1


On 19/05/2006, at 12:13 PM, Chris Dagdigian wrote:
> I upgraded gridengine.info to trunk last week from a
stable yet
> really ancient base version. The upgrade went very
smoothly but I
> just noticed some issues when posting articles using
Mars Edit 1.1.2.
>
> The symptoms are as follows:
>
> - post goes through fine, xmlrpc console shows no
errors
> - article summary shows up on the main page
> - clicking on the article header to go to the full
pieces produces a
> polite "article can't be found" error
> - clicking on a tag (if it is new) will show a polite
"tag does not
> exist" error
> - article does not show up in category view or tag view
>
> Once I login to Typo, select 'edit' and then 'save'
everything is
> created and works fine.
>
> Anyone else see this with external tools? Posting that
partially
> works? My SVN info says Revision: 1053

I was getting that a while back, in my case though it was
because  
publishing via MarsEdit wasn't setting the 'published'
flag.   I've  
since switched to Ecto, which for some reason didn't
exhibit the  
problem on exactly the same version of Typo.  Never really
understood  
why.

Your issue could be different though, because in my case I
didn't  
just have to hit edit and save, I had to set the published
flag  
manually too.

TX

-----BEGIN PGP SIGNATURE-----
Version: GnuPG v1.4.3 (Darwin)

iD8DBQFEbS9MuMe8iwN+6nMRAqqjAJ95qx2N2Hlf220KpcF1kMz5EH/pogCe
P7fh
vkYTbXphBozgrIZv5Edeazk=
=81gy
-----END PGP SIGNATURE-----
_______________________________________________
Typo-list mailing list
Typo-listrubyforge.org
http:
//rubyforge.org/mailman/listinfo/typo-list