There seem to be a DBUS request/reply used by
the battery applet to request current level, see here:
http://maemo.org/pipermail/maemo-developers/20
07-March/009300.html
Plus messages sent when the level changes.
However my question:
"I couldn't find documentation on the maemo site for
these bme/mce
messages, is the protocol I described considered stable (eg:
supported
for new releases)? Did I miss obvious messages or got wrong
semantics?"
Went unanswered, may be I should open a bugzilla for more
visibility?
Laurent
On Wed, 2007-04-18 at 16:14 +0530,
ext-chaitanya.chaitanya nokia.com
wrote:
>
> Hi,
>
> I've been trying to find a way to retrieve battery
information for a
> N800. I am not able to isolate the function call used
in getting this
> information. I tried listening to D-BUS messages, but
this only works
> when the user manually launches the battery applet (on
the top status
> bar).
>
> I am not able to find any HAL libraries on the device
either, so am
> not sure whether HAL exists for the device or not.
>
> Could you give me any information on how this data can
be retrieved?
>
>
> Thanks and Regards,
> T Chaitanya
>
> _______________________________________________
> maemo-developers mailing list
> maemo-developers maemo.org
> h
ttps://maemo.org/mailman/listinfo/maemo-developers
_______________________________________________
maemo-developers mailing list
maemo-developers maemo.org
h
ttps://maemo.org/mailman/listinfo/maemo-developers
|