jim tate wrote the following on 07/24/2007 04:02 PM:
> Running NX on a remote client that worked fine. until,
> I installed a Linksys WRT54G router in front of the
remote client and 
> did a "Port Forwarding"
> in the Linksys to the remote client, and I can
communicate perfectly 
> with remote client using SSH -X in Linux, Both
Computers are Fedora 
> Linux, but when I run NX to connect, it says
> "Authenticating Completed" then when it says
it is "Negotiating Link 
> Parameters"
> and it fails to connect.
>   
Hi Jim,

I have seen this Negociating Link Parameters thing from time
to time
which causes a timeout.  Sometimes even after the screen
comes up and is
usable.  I think it has something to do with a past client
session still
running.  It's easiest to ask the user to log out of their
local desktop
session (killing off old NXclient session processes).  After
logging
back in they seem to be able to login again.

-Joe

____________________________________________________________
____
     Were you helped on this list with your FreeNX problem?
    Then please write up the solution in the FreeNX
Wiki/FAQ:
  http://openfacts.berlios.de/index-en.phtml?title=Free
NX_FAQ
         Don't forget to check the NX Knowledge Base:
                 http://www.nomachine.com
/kb/ 

____________________________________________________________
____
       FreeNX-kNX mailing list --- FreeNX-kNXkde.org
      http
s://mail.kde.org/mailman/listinfo/freenx-knx
____________________________________________________________
____