LJ 4050 Blank Pages? RESOLVED

Dave-
A half-test would have shown this up early on in the troubleshooting phase.
Hind-sight is wonderful, isn't it?

Regards...........Jim/KMR/Chicago

At 09:25 PM 8/23/2006, you wrote:

>OK,
>
>I checked the cables again and again because that is the only thing
>;that made sense. Turns out one of the users had changed toner drum on
>me wo pulling out strip. I would have never checked for that because
>it was printing fine when I took it apart. LOL. Thanks for ideas guys!
>;
>Dave
>
>;--- In
><mailto:printerrepair%40yahoogroups.com>printerrepairyahoogroups.com,
>&quot;John Galusha&quot; <jgalusha...> wrote:
&gt; >
> > You may have done this already,
> >
> > I would remove the engine board and check/clean the spring contacts
>and all
> > other ground contacts.
> >
> >
> >
> >
> >
> > -----Original Message-----
> > From: <mailto:printerrepair%40yahoogroups.com>printerrepairyahoogroups.com
&gt;[mailto:printerrepairyahoogroups.com]
> > On Behalf Of davehayden55
> > Sent: Friday, August 18, 2006 8:50 AM
> > To: <mailto:printerrepair%40yahoogroups.com>printerrepairyahoogroups.com
&gt; > Subject: [Laser Printer Repair] LJ 4050 Blank Pages?
&gt; >
> >
> >
> > Hi
> >
> > I replaced a main drive assembly in a LJ 4050 and am now getting blank
>; > pages. The same number as the printed document. Engine test page is
> > the same. I assume I did something stupid like not plug something in
> > but I have reseated cables and formatter with no success. ANny ideas?
&gt; > Thanks!
&gt; >
> >
> >
> >
> >
> > [Non-text portions of this message have been removed]
> >

[Non-text portions of this message have been removed]