In reverse order. There's a setting on the configuration menu,
something like "new toner=no" change it to yes and it resets the bar
graph. When you get to a low toner messgae and change the toner, the
printer should display the message with an "=yes" and you select it to
reset. No realpurpose though, not all that accurate and no bearing on
when the printer displays low toner. Not to be confused with the newer
model with chips on the toner cart.
I don't recall on the light, I do know they do turn off like the 4000.
You could try a "cold reset"; which will restore the factory settings.
Kent
--- In printerrepair%40yahoogroups.com">printerrepair
yahoogroups.com, "irv6744" <irv6744...> wrote:
>
> i just got a used lj 4050 and have two questions.
>
> the display light stays on.
> on my lj 4000, the light went off after a few minutes.
> is there any setting to turn the lj 4050 display light off.
>
> the toner gauge on the configuration page reads empty on 2 cartridges.
> any way to reset the toner gauge so i am getting a more accurate
reading.
>
> thanks
>
.