Re: HP LJ4250swing arm replacement

Andy

Thanks for this link !
.
Just what the doctor ordered ............
.
Say Stuart ........ how's the shutter bug doing ?
.
Mike

.
.
.
.
.
On Wed, 24 Jan 2007 08:35:03 -0500 "Andy Brasfield"
<; abrasfield%40southeasternlaser.com">abrasfieldsoutheasternlaser.com> writes:
> The procedure described by Parts Now is the long way. Take a look
> at
> the short method at the follow url:
>;
> http://www.libertypartsteam.com/swing_plate.html
>
> I use this shortcut. It is much quicker.
>
> Andy
>;
> >
> > Don,
>; >
> > It doesn't look too bad to get at.
> >
> > Here's an excellent instruction guide with photo's:
> >
> > <http://www.partsnow.com/service_today/0106.asp>
> >
> > It looks like I'll be getting my Swing Arm kits from PartSmart
> > (Europe)
> > who are based in Berlin.
> >
> > Thanks to Zen He (in Berlin) who was kind enough to reply late on
> a
> > Sunday evening (it was probably 1am Monday over on the European
> > mainland - I'm never sure!)
&gt; >
> > Best regards,
> >
> > Marcus
&gt; >
> >
> >
> > -----Original Message-----
> > From: printerrepair%40yahoogroups.com">printerrepairyahoogroups.com
> > [mailto: printerrepair%40yahoogroups.com">printerrepairyahoogroups.com]On Behalf Of Don Backman
> > Sent: Tuesday, January 23, 2007 11:01 PM
> > To: printerrepair%40yahoogroups.com">printerrepairyahoogroups.com
> > Subject: Re: [Laser Printer Repair] HP LJ4250swing arm
> replacement
> >
> >
> > Hey, 4250 fuser drive gear problem.. Thanks for talking about it,
> you
> > must have jinxed me -1- just came across my desk. Ordered the
> parts
&gt; > ...
> >
> > Anybody done one of these yet? Is is like the 4 and 4+ gears that
> have
>; > to be accessed by removing everything from the r side of the
> printer?
> >
> > I have a 4200-4300 svc manual but no 4250 manual, but I'm assuming
> the
> > engines are the same?
&gt; >
> > Is this a pain in the a$$ job? Just wondering ahead of time, no
> big
> > deal. I have a flyer about changing the swing arm on a 4345MFP
> ...
> > similar?
> >
> > Thanks,
> >
> > -Don
>; >
> >
> > Stuart Woods wrote:
&gt; > >
>; > > You can either buy a new swing plate assembly or just replace
> the
> > gear.
&gt; >
> >
> >
> > > > Marcus Jones wrote:
&gt; > > >
>; > > > Hello,
&gt; > > >
>; > > > I have a LJ4250 which has a worn out fuser drive
&gt; > > > gear. This is part of the swing arm assembly RM1-0043.
> > >
>; >

> --
> Andy Brasfield
> Southeastern Laser
&gt; www.southeasternlaser.com
>;
> Mark 9.37

Messages in this topic (12) Reply (via web post) | Start a new topic

.