Deskjet 882C Carriage belt replacement

I'm needing top replace the printhead drive belt.
It appears to be fastened to the printhead. any tips on how to download
a service manual for this pepair? I do have the printer diagram off the
HP website..
But it isn't very good. No real help as to how to get to replacing the
belt.
Hank

Messages in this topic (1) Reply (via web post) | Start a new topic

.

I don't think there is a manual but if you have any skills you won't need it.

Hardest part is getting off the covers and that is just a couple screws and some clips that can be tricky to find. After that you just have to pull the carriage rod out and you can access the back of the carriage and voile! Now the hard part is finding another belt. (I left out a lot of steps, just look what you are doing and you should be able to figure them out, the belt is usually spring loaded on the right to release the tension.)

Greg

----- Original Message -----
From: hjtrepp
To: printerrepair%40yahoogroups.com">printerrepairyahoogroups.com
Sent: Thursday, May 10, 2007 9:24 AM
Subject: [Laser Printer Repair] Deskjet 882C Carriage belt replacement

I'm needing top replace the printhead drive belt.
It appears to be fastened to the printhead. any tips on how to download
a service manual for this pepair? I do have the printer diagram off the
HP website..
But it isn't very good. No real help as to how to get to replacing the
belt.
Hank

[Non-text portions of this message have been removed]

Messages in this topic (0) Reply (via web post) | Start a new topic

.