Re: hp 4mv feed roller shaft replacement

Hi. Remove the cart. Remove top cover(two screws, lift up push back
unhook control panel connector) and right side cover Remove 2 screws from the
base in cart cavity and lift out. Remove two screws from shaft.. Disconnect
feed clutch and slide pick up shaft out. Take care when re-installing to
properly align the paper feed clutch , positioning it in the slot on top.
That's it ...Have fun Steve

************************************** See what's free at http://www.aol.com.

[Non-text portions of this message have been removed]

Messages in this topic (0) Reply (via web post) | Start a new topic

.